StorageTek 9840 Bedienungsanleitung PDF herunterladen (Seite 188)

SCSI Change Configuration Menu

6-32 Sixth Edition 95741

Drive Node World-Wide Name Submenu

Note: Firmware release level 1.30.111, and up, can create a “Custom” WWN as required for

special circumstances.

Make sure a Custom WWN is unique, and registered in Host interface software.

Unregistered or duplicate WWNs will cause Host interface anomalies.

H=xxxxxxxx

L=yyyyyyyy

Defaults to last saved selection.

H=xxxxxxxx, together with

L=yyyyyyyy, comprise the

unique 64-bit WWN that identifies

this specific drive.

Pressing

Select when all digits are

steady, starts the change mode.

The left-most hexadecimal digit

begins flashing and will

increment up one value with

each additional press of

Select.

Pressing Menu sets the flashing

digit at displayed value (0-F), and

advances flashing to the next

digit. When the last digit is set, a

second press of

Menu advances

menu to next submenu. Pressing

Select restarts the left-most digit

flashing.

1. Press

Select to start change mode;

or, press

Menu to bypass.

2. Press

Select to increment digit

until desired value is displayed,

then press

Menu to set.

3. Repeat step 2 for each digit.

4. Press

Menu to advance to the next

submenu; or, press

Select to

restart change mode.

Drive Node Custom/Normal WWN Submenu

Note: This submenu only appears if a Custom WWN is in use, or is being created.

WWN Custom

WWN Normal

Custom is default selection.

Normal selection recalls the

stored Normal WWN from the

drive EEPROM.

Currently, a password (use 500) is

required to save a new Custom

WWN, or to reset a Custom WWN

back to the stored Normal WWN.

Password requirement will not be

in future firmware releases.

1. Press

Menu to invoke Custom

WWN, and advance to the next

submenu; or

2. Press Select to toggle option;

then, press

Menu to reset WWN to

the stored Normal WWN, and

advance to the next submenu.

Note: If valid password is not entered, change to the WWN will not be saved.

Table 6-2. Menu Table—SCSI Configuration (Continued)

Options Notes Procedure

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 249 250

Kommentare zu diesen Handbüchern

Keine Kommentare

StorageTek 9840 Bedienungsanleitung Seite 188

Kommentare zu diesen Handbüchern